Help placing bridges.....

I know it doesn't show up right in WE and Iknow the page up/down stuff, but is there a way without opening war3 and testing it to know if it works right? I have quite a few bridges all over the map and instead of using war3 and testing each one individually, is there an easier way?

if there is a way, i have not found it yet =(

Do you mean testing to see if they fall down some when you load or testing to see if they're walkable? If you mean testing to see if they fall down then hit pg up then pg down. It'll lock their position without actually changing it (I guess you knew that though)

If you mean testing to see if they're walkable I'd suggest Just eyeballing them from the side to see how far the ends are off the ground. They should be just a hair off the ground then they'll work fine every time. You can also turn on pathing to see if you put it too near the edge of a cliff. It'll show a purple line that'll show where it starts getting impassable.

Yes, what Blo0d-Angel said. Press 'P' in the WE to turn on pathing and look for pink at the edges of your bridge. Adjust height till it's gone and it will work.