Infernals

Ok, please bear with me this might take some time.

Ok on this map im doing i wont 4 infernals to fall out of the sky and ambush this war party, i got it so 4 infernals appeared but they did not fall from the sky and after 30seconds their was over 100 infernals because the trigger was set for

"unit enters region"

"create 1 Infernal at Center of Region 1"

"create 1 Infernal at Center of Region 2"

"create 1 Infernal at Center of Region 3"

"create 1 Infernal at Center of Region 4"

Then i tried something else and when a unit entered a region i got some trees to fall down and a infernal to play its birth animation but i got no falling from the sky.

So please could someone help me with this problem, all i need is a few infernals to fall from the sky.

And also if anyone could help me "unit enters region", because when i do it, it works but then over and over again it will play the same thing, so for example if a warden entered a circle of power and i wonted it to say "do not enter this grove" it would do that but over and over again, i tried conditions like if warden 00 enters region then do action - "blaaballalala"

But then the same thign happens but only with that warden?

Plz can someone help?

Lance

Honestly, the easiest solution might just be to create a new neutral hostile unit at the region. Make sure this unit is hidden and has the Rain of Chaos ability. Issue an order to the unit, where the order is Rain of Chaos and targets the point center of region. Then remove the summoning unit.

Otherwise, you are going to need to play with the special FX .mdx for the Infernal, use a wait to synch that effect with the creation of the infernal and also deliver AOE damage to wherever the infernal lands. Much more complicated.

Just create a unit and give it 4 Infernal Stones. Also make sure you Hide that unit. When a unit enters that region order it to use a infernal stone at Region1 (Hero-UseItemOnPoint), wait about 0.5 seconds and order it to use another inferal stone, continue for the remaining 2. Also if you only want this to happen once add Trigger-TurnOff(ThisTrigger) as the first action.

thx for that guys, il try it out now :D

Lance