Zepir's Editor

When I make a new map and save it, it automatically protects it. How can I stop this from happening in Zepir's editor?

Edit->Map Protection

This shouldn't be happening. By default Zepir's editor does not protect maps. Go into the map properties interface and into the protection section. Make sure that enable protection is unchecked and that the type of protection is set to 'none'.

~kharma

Ok, I make a map in Zepir's editor I immediatly save it and do nothing else. I quit the editor and try to load it up in World Editor Enhanced and it says "Cannot load file xxx.w3m". (I try to load it up in world editor because Zepir's editor is too complicated, hard, and wierd. Can't figure a thing out) Then I go back to Zepir's editor and try to open xxx.w3m and it says "Enter Password". I don't remember ever putting a protect on it. I go into it by clicking cancel and it says "blah blah you wont be able to save work blah blah read only". and I go check the protect. There IS a protect, its enabled and everything but I never put one on.