| 01-16-2004, 12:40 PM | #1 |
i know this has probably been asked many, many times, but can anyone give me a short tut on how to use bridges? i cant seem to make them do anything but look nice ( cant walk on them) and yes, the editor has walkable on. |
| 01-16-2004, 02:31 PM | #2 |
Firstly place the bridge between two points such as a pair of cliffs (which I'm assuming you have done). This should normally make it work but look strange in-game. Next select the bridge, hold down control (I think) and press page up or page down to raise or lower the bridge until it looks right. If you have followed those instructions it should work. That's how I do it anyway. |
| 01-16-2004, 04:52 PM | #3 |
Click "Veiw" then "Pathing - Ground" the whole map should be covered in different colors now... Move the bidge around until the ends are NOT colored red, and it should be pathable. (Red is unwalkable in pathing) |
| 01-16-2004, 07:41 PM | #4 |
Also, it's very good to know that you can raise and lower your bridges so that they are plum with the ground. It's always funny to see a bridge floating out in the middle of nowhere. To raise and lower doodads, hold control and press the page up/down buttons. :D |
| 01-16-2004, 08:12 PM | #5 |
ok thanks everyone i hjave got it now, i was just wondering why i couldnt place units on the bridges in the editor, never actually tested it =P thanks for all your help. |
| 01-17-2004, 12:39 AM | #6 |
It also works with other doodads. Lowering and rising them. :foot: |