Raising land.

I want to raise a 4x4 section of land to a certain height. I raise it once and its fine but when I raise it twice another peice of land rises below it. It make it look like steps. I just want a 4x4 peice of land to get pretty high. Is there any way to get around this?

You can't have cliffs more than 2 high is why it does that, the only way to make cliffs higher is to use the Height and Platue tool instead of cliffs, but do that an units can walk up the "Cliff" unless you place pathing blockers.

I think Bulletbutter was using raise and lower problem is: usually you cant make cliffs to steep with raise and plateau ... you have to make a folder in your warcraft directory named "UI" and than add the file below there than you can make eam as steep as you want...

If you don't want to place pathing blockers: Here's the solution.. (it's not a link, don't try to click "Here")

First use Raise and Plateau tools

Then you make a cliff by using the cliff tool "raise one" or "raise two"
Then you will have a good lookin, really high cliff.. Yeap Yeap

Don't forget to rotate your camera if you need to! Ctrl + Arrow Keys.