Help! So simple yet i'm still confused..

When doing bridegs/ramps, why do the units popup 2 meters everytime they go down/up? I've tried to raise/lower at the locations but so far it haven't worked..

hu? wut do u mean by pop up two meters? o_O

Example: a knight is running down a ramp.

As he takes his first step up on the ramp it looks like he takes a big stairstep, then he walks down the ramp. When he's going to get off the ramp he does the same thing again. o_O

umm maybe theres a a difference of levels, try using crtl + pg down to lower it a bit that should work, if not post a ss piz

o_O
Doesn't work.. I've had this problem years ago when I tried the editor for the first time, I think I found the solution and said "ahh so simple".. grml

post a screen shot so i can get a better look, better if its a side ways one

It has to do with ramp/bridge pathing. Use invisible platforms and raise them between the bridge and ramp. -nod nod-

It's really nothing special, I put a ramp from the ground, up to a lvl 1 cliff.. and every time any unit steps on the top or lower point to get off the ramp it takes 1 step up or wtf to call it..

Invisible platforms?

-nod nod- They should be under Bridges/Ramps directory. Turn on pathing view, however, its useful when placing them (press P).