Animation Issue

I have a modified Footman Model (Gave him the larger of Arthas' shoulder pads on both shoulders, sword from the Lothar model on WC3Sear.ch, hero glows, and a dissipate animation) which I have a minor animation problem with. No, the animations did transfer correctly, it's just one of the animations is out of position. The dissipate animation (Transferred from the beastmaster) plays fine, but it is quite a ways behind where his body ends up at the end of the death animation. Does anyone know how to move the animation in question to the correct position, relative to the death animation? It doesn't look that great when he floats up into the sky a few feet behind his body. The .mdl is attached, in a zip.

'Fraid not. The problem is, dissipate and decay animations are specific to the death animation used in the same unit. I'd reccomend that you add the Beastmaster's death sequence too.

I tried that, but the beastmaster's death doesn't transfer, for some reason. I remove the original death animation, use oinkerwinkles anim transferer to get the beastmaster's death animation, convert the new .mdl into a mdx, and have no death animation whatsoever. maybe you could try it...

take out dissipite animation (sing oinker's tool, not by hand or u will ruin it) then add uther's dissipite anim, is much like footman death.

I tried using Uther's dissipate (Though any model with the paladin's animation would have done) and it doesn't work properly. His upper body just bobs up and down for a bit. I wish I could attach a gif from WC3viewer, but I can't get it to export a gif.

Don't rely on wc3viewer. Always test your model in-game.

I believe Oinkerwinkle's animation transferrer may be case sensetive - if an animation is not transferring, try "Death" instead of "death".

Can u post that tool, I mean that animation remover tool?

Done.

thankz