| 01-12-2003, 02:41 AM | #1 |
I hope this is the right place to put this but here it goes. I have a spot where the terrain is 2 (units?) high, then it connects to one that's 1 high. Is there a way to place a ramp from the 2 to 1? it doesn't seem to work...at least as simple as it does 1 to 0. Thanks for any help. |
| 01-12-2003, 03:11 AM | #2 |
Guest | The 2 units high often causes problems i do this 4 tall 4 wide on 2 units, then its like l l l l _ _ _ _ Then i add this to it l l l l⌠_ _ _ You know what i mean? then use the ramp tool and mess with it until it works. hope this helps.. Another Tip: make sure there wide enough for it to come down like 4 units wide 4 units tall, so you give enough space for when you go up the ramp understand? hope this helps you out. AfterShock- |
| 01-12-2003, 03:45 AM | #3 |
Sorry, i'm a bit slow...I don't really understand  How high would that be? |
| 01-12-2003, 03:47 AM | #4 |
Guest | he's not alone, I didn't really get what you were talking about either. What "units" were you refering to? because i think he was refering to cliff levels. (not sure though) |
| 01-12-2003, 04:51 AM | #5 | |
Guest | Quote:
Basically, you need to have a certain amount of room to place a ramp. Make sure the ramp isn't near another ramp ont he same or different level, and it has plenty of cliff all facing at the same angle. |
| 01-12-2003, 04:55 PM | #6 |
Wow that was easier then i thought! :ggani: Thanks for the heads up random. |
| 01-13-2003, 08:11 PM | #7 |
Guest | you can turn on pathing in WE to see where you can place ramps too |